Gemstart 2 Hand Held Programmer HHP
As hand held programmers for older Gemstart units are becomming very difficult to obtain, we thought that we should make our own.
After a lot of investigation we have designed an interface unit that allows all the functionallity of the original Gemstart 2 hand held programmer to be duplicated.
The interface unit connects to the Gemstart 2 in the same way as the original HHP did. It allows the user to do all the things that could be done with the original, and more. With this you can:
- Start and Stop the attached motor
- Setup configuration parameters
- Monitor the status of the Gemstart and attached motor
- Reset trips and faults
- Accept Gemstart address changes
- Store the configuration of 100 Gemstarts
- Work with a PC based application to view or print the stored configurations
User Friendly front screen:
Alarms are presented in an easy to view format:
Configuration of parameters is easy here is an example configuration page:
The configuration data from a Gemstart can be stored using onboard EEPROM. There is capacity for 99 Gemstarts configuration data, referenced by the address 0-99.
This stored cofiguration data can be uploaded to a PC based application and can be transfered to Excel for printing either as a single Gemstart.
Or all 99 Gemstarts:
The data can then be processed within Excel.
Connect to us using:
Contact us for more information Tel +44 1782 834177
www.apstar.co.uk